Where is sysprep located windows 7

It starts by running the Windows Welcome program and initializes settings on the computer. You must select this option to prepare a computer for imaging. If you do not run Sysprep again, it will never enter the Windows Welcome phase but will instead continue to boot into System Audit mode. Generalize: The Generalize check box causes Sysprep to remove system-specific information from the computer.

You must check this option to prepare a computer for imaging. Quit: This option quits Sysprep but doesn't shut down the computer. Generalizing a Windows installation uninstalls these configured devices, but doesn't remove device drivers from the PC. If you're deploying an image to computers that have identical hardware and devices as the original PC, you can keep devices installed on the computer during system generalization by using an unattend file with Microsoft-Windows-PnpSysprep PersistAllDeviceInstalls set to true.

You can run Sysprep command up to times on a single Windows image. After running Sysprep times, you must recreate your Windows image. Refer the following table:. In previous versions of Windows, you could use the SkipRearm answer file setting to reset the Windows Product Activation clock when running Sysprep. If you are using a volume licensing key or a retail product key, you don't have to use SkipRearm because Windows is automatically activated.

Installing new Microsoft Store apps or updating your existing Microsoft Store apps before generalizing a Windows image will cause Sysprep to fail. Instead of using the Microsoft Store to update your apps, you should sideload updates to your line-of-business apps, provision offline-licensed Microsoft Store for Business apps for all users, or have end-users update their apps by using the Microsoft Store on their destination PCs.

If Microsoft Store access in a managed environment is disabled by an IT administrator, end-users will not be able to update the Microsoft Store apps. To generalize an image, you have to first boot into Audit Mode.

Boot a PC into Audit Mode. You can choose to either close the System Preparation Tool window or allow it to remain open. Customize Windows by adding drivers, changing settings, and installing programs. Caution, do not enter and do not press the Next button Next yet. Immediately after this key-press, the computer restarts automatically and logs into Windows 7 with the Administrator account.

Note : When you enter Audit mode your will remain in the same status audit mode automatically even after multiple restarts when installing updates and applications. The Audit mode is exited with the shutdown process through Sysprep. The Sysprep window will appear automatically on the desktop, which will allow us to complete the system preparation process.

For now and until you complete the final image of the operating system, you will not need it so choose Cancel to continue. Now you can install all updates, applications and anything else you want to have pre-installed on the Windows 7 deployment image you create.